Calmatron E - 6 kg

Used as a waterproofing material for water, moisture And antifungals both as a coating and as a filler.

• • When used as a spray, the consistency of the solution should be like a thin layer, ie 160-180 milligrams of water is added to 1 kg of powder. The vortexing process is carried out with a mixer until a homogeneous mass is obtained (1-2 minutes on low speed). It is a necessary condition - the surface must be watered (applied) before applying;
• The filling process is carried out with any handy tool (even by hand).
• In this case 100-120 mg of water is added to 1 kg of material and the vortexing process is carried out using a mixer until a homogeneous mass is obtained. (1-2 minutes on low speed). • If the water flow is filtered under high pressure, please contact us or write to us As a rule, the problem of water filtration (inflow) is different, therefore the cost of the material will be different each time.1. Before applying to the work surface, the pores should be opened with a metal brush, perforator, Or using another handy tool.

        2. The surface should be washed after opening the pores.

        3. After rinsing the surface should be primed with KALMATRON-E solution (1: 4 kalmatron-water In proportion).

        4. KALMATRON-E must be processed on the ground surface no later than 10 minutes after grounding With solution.

        5. KALMATRON-E treated surface especially during the first 6-10 hours It should be watered (watered) several times, and the watering process should be continued Within 72 hours.